Kunshan Duyang CNC share: The correct maintenance method of CNC drilling and tapping machine

 Drilling and tapping machine is a kind of metal cutting machine tool, CNC processing equipment. The main structural castings are made of high quality Meehanna cast iron with stable structure and permanent quality. Through finite element analysis computer calculation analysis, reasonable structural strength and reinforcement rib matching, to provide high mechanical rigidity. 

The three axes are supported by line rails, which can support heavy loads and move quickly to ensure accurate positioning. The base is wide and solid, the column is box-type structure, the saddle is widened and lengthened, the load is fully supported, and the structure is solid, which can ensure the heavy load capacity during processing. The frame inside the spindle head strengthens the structure, and the contact length ratio between the spindle head and the column is appropriate to provide stable support for the spindle. 

 The correct maintenance method of Kunshan CNC drilling machine: 1, CNC drilling machine should often carry out air compressor drainage, because if the air compressor water too much is not discharged in time, it will be brought to the air motor, over time, the bearing becomes flexible. 2. The oil cup of the double coupling (the cup on the right) should be refueled. As long as the air motor is composed of bearings and gears, it needs lubrication. Refueling, the work is flexible, CNC drilling machine is durable. 3, often to the bushing oil. CNC drilling machine should be regularly maintained, if the CNC drilling machine oil has garbage to be removed, re-add. Taken to the motor, over time, the bearing becomes inflexible. 4, to often check the cleaning of the moving parts of the high-speed drilling and tapping center machine friction, appropriate injection of lubricating oil. 5, to prevent debris accumulation on the rotor end and terminal, the operator should use a vacuum cleaner to clean the rotor end of the spindle motor and the terminal of the motor after work every day, in order to prevent debris into the bearing, accelerate the wear of high-speed bearings; Prevent scrap from entering the terminal, so as not to cause motor short-circuit burning. 6, in the daily maintenance, it is necessary to regularly check the loosening of the moving parts and screws and nuts to avoid danger. 7, when the operator leaves the high-speed drilling and tapping center equipment, it is necessary to stop the operation of all parts of the equipment to prevent others from misoperation and danger.